Previously, in the manufacture of cable harnesses, the cable was pulled through the sleeve without a connector, after which the connectors were installed. If an error was detected during the formation of the cable bundle, then the entire bundle was considered unsuitable and sent for revision. Thanks to the new FreeCon cable connectors, this is no longer necessary, since the compact connectors go inside the sleeve, which means that only pre-assembled and tested lines are laid in these bundles.
Compact design simplified cable assembly for the automotive industry. The miniature dimensions of the connector allow pre-assembled and tested cables to pass through the cable sleeve. Cable sleeves can also be used in conjunction with connectors and with overhead cables.
The innovative design of the FreeCon cable glands provides fast and convenient cable connection for robots.
Simple and reliable interfaces
Cable glands are characterized by mechanical reliability (robust metal housing) and IP 65 protection level.
Robust mounting frame
Extra strength is achieved through a mounting frame up to 10 mm wide.
Simplified cable harness diagram
Miniature dimensions allow you to lay pre-assembled and tested cable lines in cable bundles.
Connect in a short time
Easily screw cable glands with V14 bolts using an Allen key (SW27).