High-performance power supplies must operate efficiently and reliably even in tough industrial environments. High overload capacity, long service life and optimal protection against surge input voltage, vibration and extreme temperatures – all these are modern requirements for a reliable power source.
New DCL technology provides PROtop with an outstanding range of overload protection. This can be used to reliably turn off the machines, as well as to start a powerful engine.
Power supplies are available with output voltages from 12 to 48 V and currents from 3 to 40 A. Pay attention to the dimensions of the device: PROtop 240 W 10A has a width of only 39 mm, while having a built-in ORing module for redundancy.
Ability to select operating modes
In parallel operation (P: parallel connection, S: single mode), the output voltage can be easily adjusted, and the output currents can be balanced symmetrically. Programmable short circuit behavior (C: DC short circuit, S: shutdown), offers some protection for additional protection of the wired connection.
High peak power and superior dynamic range with DCL technology
Innovative DCL technology guarantees reliable operation of the machines by increasing the output current by at least 600% for 20 ms. In addition, increased overload capacity ensures the launch of a powerful engine.
Efficiency, space saving and long life
Efficiency up to 94.5% gives a small loss of power and allows you to place power supplies in extremely narrow cases. Low heat guarantees a high MTBF (more than 1,000,000 hours) and extends its life.
The maxGUARD electronic fuses in combination with various terminal blocks and accessories will ensure suitability for any application.
